1800 Pennsylvania Ave. West Warren, PA 16365

1-800-831-7160 | info@bettsind.com

40 Series, Stop, Turn, Tail, Shallow LED Lens
Print this page.
40 Series lamp assemblies use a plastic body with a LED lamp assembly and use a 4 hole mounting pattern and require a ø4.75 clearance hole for the body.
Replacement LED lens assemblies can be found here: (link to LED lens assemblies page)

Sequential turn LED lamps can be used as an additional rear turn or used as a mid-turn when combined with the required marker lamp. For optimal sequencing turn signal flash rate should not exceed 85 flashes per minute.

The following is a list of available maintenance and installation manuals, technical and engineering bulletins, and

specification sheets for this product line.  If you cannot find what you are looking for, please contact one of Betts’ Customer Service Representatives for further assistance.

  • None currently listed.

Betts prides itself in being able to provide products that meet a customer’s specific needs. As a result we do offer modifications to our product standards. While not every request is always feasible, we do our best to meet your specific needs. In many cases this modification is noted by adding a suffix to the end of the standard part number.  The following is a non-inclusive list of common options that are available for this product line .  If the options listed below do not meet your requirements please contact one of Betts’ Customer Service Representatives for further assistance. Please note that some product modifications may result in extended lead times.

Commonly Requested Options:

  • None at this time.